11
1. Capacitor
2. Control Box
3. Ring Blower 4.
Power
Switch
5. Fuse
6. Air Intake Filter
7. Cabinet
8.
Rubber
Feet
9. Drainage
10. Air Intake Pipe
11. Air-Out
12.
Signal
Line
13. Power Cord
3.2 Procedures of installation
3.2.1 Installation:
(1) Check after unpacking.
Ensure that every component of the unit is intact after opening the box and
check that spare parts are intact according to packing list. In case of doubt,
please contact our company or your local agent.
(2) Precautions of installation.
The electric units should be installed by competent person only.
(3) Condition of installation.
a. Ambient temperature: 5
℃
~40
℃
b. The unit should be well positioned to ensure there is an adequate airflow
around the machine.
(4) Method of installation.
a. Install the unit close to treatment unit, and ensure mounting level of
suction unit lower than treatment units. Please note that the door of suction
unit should not be opened freely for safety.
b. The suction unit should be well situated to ensure it has 25cm space free
of obstacle around two sides of case.
(5) Specifications of connecting pipes.
a. Pipe connects suction unit with dental treatment unit:
Material: PPR or PVC
Air-Inlet Inner diameter: φ32.
Length: ≤5m
Height of installation: 0.5m higher than bottom of suction unit
b. Pipe connects air outlet with outdoor pipeline:
Material: PPR or PVC
Inner diameter: φ32
c. Pipe connects drain water exit with outdoor waste processing pipeline:
Material: PPR or PVC
Inner diameter: φ20.
Height of installation: lower than bottom of suction unit
(6) Electrical requirements
