Modellbau Lindinger GmbH
Alte-Post-Str. 14 A-4591 Molln e-Mail:
www.lindinger.at
0 • VELINEON POWER SYSTEM
3.
When the LED blinks
red once, release the
EZ-Set button.
4.
The LED will blink and
then turn solid green
(Low-Voltage Detection ON) or red
(Low-Voltage Detection OFF). The
model is ready to drive.
Selecting Race Mode
(Profile #2: 100% Forward, 100% Brakes, No Reverse)
1.
Connect a fully charged
battery pack to the VXL-3s
and turn on your transmitter.
2.
With the VXL-3s off, press
and hold the EZ-Set button
until the LED turns solid
green, then solid red and
then begins blinking red
(indicating the Profile #).
3.
When the LED blinks red twice, release the EZ-Set button.
4.
The LED will blink and then turn solid green (Low-Voltage
Detection ON) or red (Low-Voltage Detection OFF). The
model is ready to drive.
Selecting Training Mode
(Profile #3: 50% Forward, 100% Brakes, 50% Reverse)
1.
Connect a fully charged
battery pack to the VXL-3s
and turn on your transmitter.
2.
With the VXL-3s off, press
and hold the EZ-Set button
until the LED turns solid
green, then solid red and
then begins blinking red
(indicating the Profile #).
3.
When the LED blinks red three times, release the
EZ-Set button.
4.
The LED will blink and then turn solid green (Low-Voltage
Detection ON) or red (Low-Voltage Detection OFF). The
model is ready to drive.
Note:
If you missed the mode you wanted, keep the EZ-
Set button pressed down and the blink cycle will repeat
until the button is released and a Mode is selected.
VxL-3s Setup and Operation
D
Solid Green
C
Release
B
One blink Red
B
Two blinks Red
A
Green to Red to Off
D
Solid Green
C
Release
B
Three blinks Red
A
Green to Red to Off
D
Solid Green
C
Release
