SLASH
•
15
2.
Press and hold the receiver’s LINK button as you switch on
the speed control (by pressing the EZ-Set button). Release the
LINK button.
3.
When the transmitter and receiver’s LEDs turn solid green, the
system is bound and ready for use. Confirm that the steering and
throttle operate properly before driving your model.
Steering Sensitivity (Exponential)
The Multi-Function knob on the TQ 2.4GHz transmitter has
been programmed to control Steering Sensitivity (also known
as exponential). The standard setting for Steering Sensitivity is
“normal (zero exponential),” with the dial full left in its range of
travel. This setting provides linear servo response: the steering
servo’s movement will correspond exactly with the input from
the transmitter’s steering wheel. Turning the knob clockwise from
the left will result in “negative exponential” and decrease steering
sensitivity by making the servo less responsive near neutral, with
increasing sensitivity as the servo nears the limits of its travel range.
The farther you turn the knob, the more pronounced the change
in steering servo movement will be. The term “exponential” comes
from this effect; the servo’s travel changes exponentially relative
to the input from the steering wheel. The exponential effect is
indicated as a percentage—the greater the percentage, the greater
the effect. The illustrations below show how this works.
Normal Steering Sensitivity (0% exponential)
In this illustration, the steering servo’s travel (and with it, the steering
motion of the model’s front wheels) corresponds precisely with the
steering wheel. The ranges are exaggerated for illustrative purposes.
Decreased Steering Sensitivity (Negative Exponential)
By turning the Multi-Function knob clockwise, the steering sensitivity
of the model will be decreased. Note that a relatively large amount
of steering wheel travel results in a smaller amount of servo travel.
The farther you turn the knob, the more pronounced the effect
becomes. Decreased steering sensitivity may be helpful when driving
on low-traction surfaces, when driving at high speed, or on tracks
that favor sweeping turns where gentle steering inputs are required.
The ranges are exaggerated for illustrative purposes.
Experiment! Try varying degrees of exponential. It’s easy to go back
to “zero” if you don’t like the effect. There’s no wrong way to adjust
exponential. Any setting that makes you more comfortable with
your car’s handling is the “right setting.”
SETTING UP THE ANTENNA
The receiver antenna has been set up and
installed from the factory.
When reinstalling the antenna, first slide
the antenna wire into bottom of antenna
tube until white tip of antenna is at top
of tube under the black cap. Insert the
base of the tube into the antenna post.
Take care not to crimp the antenna wire.
Slide the crimp nut over the antenna
tube and screw it onto the antenna
post. Use the supplied tool to tighten
the crimp nut on the post just until the
antenna tube is securely in place. Do not
over tighten or crush the antenna wire
against the chassis.
Do not bend or kink
the antenna wire! See the side bar for more
information. Do not shorten the antenna
tube. The minimum height is 62mm.
Turning Range
at Transmitter
Effective Turning
Range on Model
To prevent loss of radio range
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct
No
No
No
TRAXXAS TQ 2.4GHz RADIO SYSTEM
Antenna
Tip
Antenna
Tube
Antenna
Wrench
Antenna
Crimp Nut
Antenna
Post
