Traxxas 74076-3, Руководство пользователя

Страница: 15 / 36

TRAXXAS RALLY • 15
TRAXXAS TQ
i
RADIO & VELINEON POWER SYSTEM
TRAXXAS STABILITY MANAGEMENT (TSM)
Traxxas Stability Management or
TSM allows you to experience all
the speed and acceleration that was
engineered into your Traxxas model
by helping you to maintain control
of the vehicle in low-traction situations. TSM helps provide straight
ahead full-throttle acceleration on slippery surfaces, without
fishtailing, spinouts, or loss of control. TSM also dramatically
improves braking control. High speed cornering and control is also
made possible as TSM makes corrections for you, without intruding
on your fun, or creating unexpected side effects.
The Multi-Function knob on
the TQi transmitter has been
programmed to control TSM.
The recommended (default)
setting for TSM is to rotate the
knob to the 12:00 position (the
zero mark on the dial).
Turn the knob clockwise to
increase assistance; turn the
knob counterclockwise to
decrease assistance. Turn the
knob counterclockwise to its
stop to turn TSM completely off.
Note: TSM is deactivated
automatically when driving or
braking in reverse.
When driving on surfaces with some traction, decrease the TSM
setting to allow the vehicle to feel more “loose” for power sliding,
drifting, and so on. On surfaces with very little traction (loose dirt,
smooth concrete, ice/snow), increase TSM to maximize acceleration
and control.
Drive with TSM on and off to test how it is making your control of
the vehicle easier and more precise. For more information, visit
Traxxas.com/tsm.
Note: TSM must be completely turned off while adjusting steering
trim.
SETTING UP THE ANTENNA
The receiver antenna has been set up
and installed from the factory. The
antenna is secured by a 3x4mm set
screw. To remove the antenna tube,
simply remove the set screw with the
included 1.5mm wrench.
When reinstalling the antenna, first
slide the antenna wire into bottom
of antenna tube until white tip of
antenna is at top of tube under the
black cap. Next insert the antenna
tube into the mount while making
sure that antenna wire is in slot in the
antenna mount, then install the set screw next to the antenna tube.
Use the supplied 1.5mm wrench to tighten the screw just until the
antenna tube is securely in place. Do not over tighten.
Do not bend
or kink the antenna wire! See the side bar for more information. Do
not shorten the antenna tube.
To prevent loss of radio
range do not kink or cut the
black wire, do not bend or
cut the metal tip, and do not
bend or cut the white wire at
the end of the metal tip.
Correct No No No
Antenna
Tip
Antenna
Tube
Antenna
Mount
Recommended setting
Decrease
assistance
Increase
assistance
TSM off