Traxxas 39085 E-MAXX, Руководство пользователя

Страница: 19 / 31

E-MAXX BRUSHLESS • 19
DRIVING YOUR MODEL
RECEIVER BOX:
MAINTAINING A WATERTIGHT SEAL
Removing and Installing Radio Gear
The unique design of the receiver box allows the removal and
installation of the receiver without losing the ability to maintain a
watertight seal in the box. The patent-pending wire clamp feature
gives you the ability to also install aftermarket radio systems and
maintain the watertight features of the receiver box.
Removing the Receiver
1. To remove the cover, remove the two 3x10mm button-head
cap screws.
2. To remove the receiver from the box, simply lift it out and set to the
side. The antenna wire is still inside the clamp area and cannot be
removed yet.
3. Remove the wire clamp by removing the two 2.8x8mm cap screws.
4. Unplug the servo cables from the receiver and remove the receiver.
Receiver Installation
1. Always install the wires into
the box before installing the
receiver.
2. Install the antenna wire and
the servo cables into the
receiver box.
3. Arrange the wires neatly
using the wire guides in the receiver box.
The excess wire will be bundled inside the
receiver box. Label which wire is for which
channel.
4. Apply small bead of silicone grease
(Traxxas part #1647) to the wire clamp.
5. Install the wire clamp and
tighten the two 2.8x8mm cap
screws securely.
6. Install the receiver into the
box and plug the wires into
receiver. Refer to page 10 for
the wiring diagram.
7. Make sure the clear plastic light pipe in the receiver box is aligned
above the LED on the receiver.
8. Make sure the O-ring is properly seated into the groove in the
receiver box so that the cover will not pinch it or damage it any
way.
9. Install the cover and tighten the two 3x10mm button-head cap
screws securely.
10. Inspect the cover to make sure that the O-ring seal is not visible.