12
REPLACING DUST SKIRT BRUSHES
The dust skirt brushes may be replaced when worn. To replace, remove the 3 screws to replace the small brush
on the half moon door and remove the 6 screws to replace the large brush on the dust skirt.
MAINTENANCE
WARNING: To reduce the risk of injury from unexpected starting or electrical shock, unplug the power
cord before working on the machine.
Keep the tool clean. Remove accumulated dust from working parts. Make sure that the tool operates properly.
Periodically check screws and bolts for tightness.
KEEPING TOOL CLEAN
Keep the machine and its air inlet slots clean to ensure correct and safe operation. To clean, blow compressed
air through the air inlet slots with the motor running at no load.
WARNING: If the replacement of the power supply cord is necessary, this has to be done by the
manufacturer or their agent in order to avoid a safety hazard.
Do not throw electric power tools into the household waste! In accordance with the European Directive
2002/96/EG on Waste Electrical and Electronic Equipment and transposition into national law, used
electricpower tools must be collected separately and recycled in an environmentally friendly manner.
OPTIONAL FLOOR GRINDING TROLLEY
This machine has built-in mounting tabs in its handle for mounting to the optional floor
grinding trolley for fatique free grinding of floors. The trolley's 4 spring-loaded
mounting plungers thread into the tabs to suspend the machine.
NOTE: This tool does not use the floor trolley's remote switching function.
CAUTION:
Do not attempt edge grinding with the machine mounted to the floor grinding trolley. The extra
leverage of the trolley will easily damage the dust shroud or turbine housing when it inevitably
contacts the wall. In addition, the range of motion allowed by the floor grinding trolley is not suitable
for edge grinding. Always perform edge grinding in hand-held mode only. Only use the floor grinding
trolley for open areas.
