background image

Media Tube

®  

HO 

Mounting Guide

www.traxontechnologies.com

©2022 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE 
WITHOUT NOTICE.

Mounting Guide

02/22 V0.8

1 of 2

Tube-to-Tube Clearance

To maintain consistent LED pitch and to 
allow for thermal expansion for Media Tubes.

See DETAIL A

See DETAIL B

Diffused Tube

Pour maintenir le pas constant entre
les LEDs et absorber la dilatation
thermique des Media Tubes.

Connector End Cap

TU.AC.0600000

End Cap Seal on Last Tube

DETAIL A

DETAIL B

69mm / 2.7”

109mm / 4.3”

23mm / 0.9”

51.5mm / 2”

24mm / 0.94”

36mm / 1.4”

296mm, 596mm, 896mm, 1196mm, 1496mm / 11.7”, 23.5”, 35.3”, 47.1”, 58.9”

81mm / 3.2”

29mm / 1.14”

Direct View Tube

54mm / 2.1”

Mounting

296mm, 596mm, 896mm, 1196mm, 1496mm / 11.7”, 23.5”, 35.3”, 47.1”, 58.9”

182mm / 7.2”

>4mm/0.16”

M6 x 23mm

Use Rear Studs For Alternative Mounting
Utiliser les goujons taraudés pour un montage différent

Loosen mounting stud may lead to
water ingression into Media Tube.
Ne pas desserrer les goujons taraudés 
sous perte d’étanchéité du Media Tube.

81mm / 3.2”

30mm / 1.2”

33mm / 1.3”

29mm / 1.14”

63mm / 2.5”

30mm / 1.2”

33mm / 1.3”

TAK!

Bouchon d’étanchéité à 
monter sur le dernier tube

IMPORTANT NOTE: 

If no “Tak!” sound is heard or connector still not mated 
well, push both connectors inwards and manually rotate 
spring head of male connector in the locking direction.

Connect

1. By pushing the cable connectors inwards, quick lock 
    connectors shall be mated and locked automatically.

2. Locking requirement of the quick lock connectors after mated:
    • “Tak!” sound should be heard
    • All 3 arrows should be in one straight line
    • Connector cannot be pull out

TAK! and lock

Wrapping

3. Wrap female and male connector as well as end cap with 3M 
    Scotch Rubber Splicing Tape 23 (or other similar self-
    amalgamating rubber tape) for secondary protection in the 
    direction opposite to the unlocking direction. 

Water-proof

4. 3M Scotch

®

 Rubber Splicing Tape 23* should be applied in 

    successive half-lapped, level-wound layers until desired buildup is 
    reached.

*For details, refer to the 3M Scotch

®

 Rubber Splicing Tape 23 Data Sheet.

1~1.2Nm

1~1.2Nm

The Max. projected area: 0.081m

2

Отзывы: