12
Installation
(For Qualified Installers Only)
© Travis Industries
4141230
100-01341
Hopper Extension Setup
1
Remove the two shipping screws on each side of the insert (see illustration on previous page).
2
Remove the hopper top.
3
Use a center-punch to remove the appropriate knock-outs from the hopper walls (9 total). The
holes are punched out from the inside. Make sure to support the hopper walls while removing the
knock-outs. In the example below the “A” position is used (tallest hopper position).
4
Place the hopper top over the hopper assembly. Line up the holes in the hopper top with the
holes on the hopper assembly. Use the 9 screws included in the owner’s pack to secure the
hopper top to the hopper assembly.
