Finalizing the Installation
23
© Travis Industries
4140813
100-01297
Glass Frame Removal and Installation (continued)
The glass latch can come loose from the glass frame. This occurs when the latch is turned 1/8 turn when
disengaged from the unit. Follow the directions below to re-install the latch if it comes loose.
Media Installation (Log, Stone, or Driftwood)
!
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
Failure to position the parts in accordance with diagrams or failure to use only parts specifically approved
with this appliance may result in property damage or personal injury.
If using propane (LP), convert the appliance before installing the media (see page 36).
The burner must be correctly positioned before installing the media. Make sure the burner is fully seated
and the pilot is properly aligned. See page 36 for details on burner removal.
For installation instructions, consult the instructions included with the log, stone, or driftwood.
Glass
Hold the latch at an angle and
insert it into the slot on the
glass frame. Note how the
washer fits in front of the flange
on the glass frame. You will
need to push slightly to get the
latch to insert.
Once fully inserted, turn
the latch until it is is level.
Latch
