Pet‐Pilot
®
MAX Wicker owners guide (rev19‐05b)
page 2 of 4
Parts Included ‐ shown below
Some assembly required
Installing the Mount on your handlebars
1.
Attach
sliding support bar
as shown above (loosely tighten both screws).
2.
Place both
rubber bushings
(see above) on handlebars, cut edge forward and centered.
a.
Hold
mount main body upper clamps
in position over rubber bushings.
b.
Place (1)
galvanized lower clamp tab
in appropriate rear slot.
c.
Install the threaded bolt for the galvanized lower clamp from the top, through the
hole in the upper clamp (snug but not tight). Repeat for other side.
3.
Center the mount clamps and rubber bushings on the handlebars.
4.
Adjust angle of the mount body (rotate mount clamp assembly on handlebars).
a.
As you adjust the mount angle, note the angle from
latch slot
to the
hooks
.
b.
This angle from the latch slot to the (2) hooks will determine how your basket will sit
… matching the angle on the back wall of the basket will make it sit level.
c.
Once you find your desired angle, slide the support bar up until it contacts the
underside of the handlebar assembly.
5.
Tighten all (4) screws and test fit the basket to check if level or slightly high in front. Loosen
and adjust as necessary to achieve your desired basket position.
