TRAPP LF-40G, Инструкция по эксплуатации

Страница: 53 / 64

ENGLISH
53
www.trapp.com.br
Fixing the Handle to the Base
2
3
7
5
6
4
9
8
Image merely
illustrative.
1
For fixation of the cable in the base, proceed as
follows:
Take the lower cable (1), fit the bore (2) to the
support pin (3).
Put the screw (4), the lock washer (5) and tighten
with the wing-nut (6).
Next, take the upper cable (7), put the screw (8), and
tighten with the wing-nut (9).
Cutting Height Adjustment
The cutting height is adjusted as follows:
Bend the adjustment rod in the direction of the
wheel (1) to unlock it. After that, move it either to
the right or to the left (2), according to the height you
wish.
The lawn mowers have several cutting heights that
must be chosen in accordance with the height and
type of grass.
2
1
Image merely illustrative.
Attention!
When adjusting the cutting height, turn off
the motor and check whether the cutting
blade is still turning before carrying out the
adjustment.
If the grass is above 5 cm of height, it must be
cut in steps in order to avoid the bushing of
the side outlet or grass catcher.
To avoid engine overload, select the cutter edge
height according to yard condition.
For the types of grass used in Brazil, it is
recommended to keep them 2 and 3 cm high
from soil. If lawn is excessively high, perform 2 or
more cutting with different height adjustments. This
procedure will help to improve equipment life.
According to cutter model (with or without grass-
holder, with side outlet), use a cutting sense as
shown in the illustrations below.