EA015 MULTI FUNCTION WORKSTATION
OPERATION MANUAL
Transmille Ltd.
Page 5
Design Notes
Incorporating the advanced clamp coil, thermocouple
simulation and tachometer calibration adapters as well as
process control source / measure capabilities, this workstation
adapter provides a versatile platform for efficient calibration of a
wide range of equipment.
Selection of the specific functions on the workstation requires use of either the EA015
Workstation adapter virtual front panel software (supplied) or use of ProCal software
procedure wizards to create procedures with built in commands for setting up the adapter
functions.
NOTE : The supplied virtual front panel software or ProCal software (optional) must
be used to set output functions.
Clamp Meters
Using the built in 2, 10 and 50 turn coils, clamp meters can be accurately and quickly
calibrated. Using a high accuracy balanced design both wound (AC only) & Magnetic field
(hall effect) AC/DC clamp meters can be calibrated. Three coils in one provide the ability to
calibrate a wide range of coils, from small lower clamps down to 10mm jaw diameter to larger
2000A clamps.
Insulation Testers
Insulation tester calibration is a common requirement and is now easy to perform using the
workstation. Insulation to 2GOhms @ 1000V and continuity to 1kOhm is available from
dedicated terminals. Using the measurement capabilities of the adapter interface, the
workstation also provides insulation test voltage measurement to 1000V and continuity
current measurement.
Process Control Calibrators
Source/measure process control calibrators are commonplace in industry and previously
required several references to calibrate. The workstation integrates all the functions required
to both source and measure the required signals.
