14
TAPMATE
™
XL-424 Operating Manual
TAPMATE XL-424 SET-UP FOR 14" - 24" taps:
For instructions on attaching the Small Adapter Bell (for 4" - 12" taps), go to page 8.
1. Remove front and rear braces from workstation.
2. With the Large Adapter Hub properly installed on the
Lead Tube (see steps on page 6), lift and move the
appropriate size and style TapMate XL-424 Adapter bell
into place (see drawing at left).
3. Remove the six nuts and washers from the outside of
the adapter. Also make sure that the gasket is in place.
4. Lift the Adapter Bell by the lifting eye, and move
it into place. The Shaft goes through the center hole
in the adapter. Carefully slide the adapter bolts
through the mating holes in the Large Adapter Hub.
5. Replace the nuts and washer back onto the adapter
and tighten.
6. Remove the Brake Tube Locking Bolt from the Brake
Tube (see drawing at left). This will allow the Brake Tube
to rotate.
