INSTALLATION
(continued)
Install Cable
COPPER
T1 100 OHM (RJ-45 CONNECTOR)
1.
Locate or build twisted-pair cables that are compliant with
specifications on page 9, with RJ-45 plug connectors at both ends.
2.
Ensure that MDI/MDI-X switch is set according to network
conditions.
3.
Connect RJ-45 plug connector at one end of cable to media
converter RJ-45 jack connector.
4.
Connect RJ-45 plug connector at other end of cable to network
equipment.
FIBER
1.
Locate or build fiber cables that are compliant with specifications
on page 10, with male two-stranded TX to RX connectors installed
at both ends.
2.
Connect cable with connector installed at TX location on media
converter to RX location on attached device.
3.
Connect cable with connector installed at RX location on media
converter to TX location on attached device.
Power the Media Converter
1.
Install the power adapter cord at the back of the media converter.
2.
Connect the power adapter plug to the AC power.
3.
Verify that the media converter is powered by observing the
illuminated LED(s).
OPERATION
After installation, the media converter should function without operator
intervention.
Status LEDs
Use the status LEDs to monitor media converter operation in the network.
SDC
Signal Detect/Copper
- Steady LED indicates twisted-pair
copper link is up.
SDF
Signal Detect/Fiber
- Steady LED indicates fiber link is up.
P(o)W(e)R
Steady green LED indicates connection to external AC power.
SSDTF10xx-105
7
6
TX
RX
TX
RX
