8
CGFEB10xx-1xx
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Port Locations
The drawings below illustrate the locations of Port 1, Port 2 and Port 3.
The CGFEB10xx-10x models include Port 1 and Port 2.
The CGFEB10xx-11x models include Port1, Port 2, and Port 3.
CGFEB100
DPX LACT PWR
Port 2
Port 1
CGFEB10xx-10x
Port 3
CGFEB100
DPX LACT PWR
Installation -- continued
Install the slide-in-module -- continued
1a. CGFEB10xx-10x:
Remove one (1) protective plate from one (1) installation slot on the
PointSystem™ chassis by removing the screw that secures the protective plate
to the chassis.
1b. CGFEB10xx-11x:
Remove two (2) protective plates from two (2) adjacent installation slots by
removing the screw that secures each protective plate to the
PointSystem™
chassis.
2.
Carefully slide the slide-in-module into the installation slot(s), aligning the
module with the installation guides.
3.
Ensure that the module is firmly seated inside the chassis.
4.
Push in and rotate the attached panel fastener screw clockwise to secure the
module to the chassis.
Port 1: 10/100/1000Base-T
Port 2: 1000Base-SX or 1000Base-LX
Port 3: 1000Base-SX (fiber tap)
[email protected] -- Click the “Transition Now” link for a live Web chat.
9
CGFEB10xx-1xx
Installation -- continued
Install the cable
Port 1: 10/100/1000Base-TX Copper Port
1.
Locate or build 10, 100, or 1000Base-TX compliant copper cables with male,
RJ-45 connectors installed at both ends.
2.
Connect the RJ-45 connector at one end of the cable to the media converter’s
10/100/1000Base-TX RJ-45port
(port 1).
3.
Connect the RJ-45 connector at the other end of the cable to the 10, 100, or
1000Base-TX RJ-45 port on the other device
(switch, workstation, etc.)
.
Note:
The AutoCross feature, when enabled, allows the use of either straight-
through or crossover configuration cables.
RJ-45 port
on the other device
(switch, work station, etc.)
RJ-45 port
on the media
converter
