Transition Networks
C4110 Install Guide
33572 Rev. B
https://www.transition.com/
Page 10 of 33
Installation and
Setup
General
This section describes how to install the C4110 and the procedures to access and initially set it up via
either a local serial interface (USB) or a remote Ethernet connection (Telnet session or Web interface).
Install the C4110 in the ION Chassis
The C4110 is a slide-in module that can only be installed in a Transition Networks ION chassis (ION106-x
or ION219-x). For a complete list of ION platform products, go to
https://www.transition.com
.
The following describes how to install the C4110 in the ION chassis.
Caution
: Failure to wear a grounding device and observe electrostatic discharge precautions
when installing the C4110 could result in damage or failure of the module.
Figure 5: Chassis Installation
IMPORTANT
The C4110 slide-in cards are “hot swappable” devices, and can be installed with chassis power on.
1. Locate an empty slot in the ION System chassis. If necessary, remove a chassis slot cover from the
ION Chassis (
keep the slot cover and screw
).
2. Grasp the edges of the C4110 by its front panel, align the card with the upper and lower slot guides,
and carefully insert the C4110 into the slot.
3. Firmly seat the C4110 against the chassis back panel.
4. Push in and rotate clockwise the panel fastener screw to secure the C4110 to the chassis (Figure 5).
5. Note that the card’s Power LED lights. See
Accessing the C4110
on page
15
.
