Transition Networks C4110-4848, Инструкция по установке

Страница: 7 / 20

Transition Networks S4110 Install Guide
33573 Rev. B https://www.transition.com/ Page 7 of 20
Installation and Setup
General
This section describes how to install the S4110 and the procedures to access and initially set it up via
either a local serial interface (USB) or a remote Ethernet connection (Telnet session or Web interface).
Install the S4110
The S4110 is a standalone module that can be deployed on its own or it can be connected to a C4110
ION Chassis card installed in a Transition Networks ION chassis (ION001-x and ION219-x). A complete
list of ION platform products is at https://www.transition.com .
The following section describes how to install the S4110.
Caution : Failure to observe electrostatic discharge precautions when installing the S4110 could
result in damage or failure of the module.
Figure 2: Installation
1. Locate the S4110 in its final install location.
2. Install SFP or SFP+ Devices in PORT 1 and PORT 2. See “ Installing SFP/SFP+ Devices ” below.
3. Perform cabling to the S4110. See the “ Cabling ” section on page 9 .
4. Make the Power Connection. See the “ Power Connection ” section on page 10 .
5. Note that the card’s Power LED lights. See “ Power and Fiber Status LEDs” on page 11 .