TECHNICAL DOCUMENT
SUSPENSION SETUP GUIDE / PAGE 4 OF 5
GIDDYUP 2.Ohh
TRANSITION LOGO FILES / 2018-19
4. Check where the O-ring is left on the shaft of the shock.
O-ring at proper sag for Sentinel 20mm
5. This is your sag. If your shock is not equipped with a sag percentage graph, use the sag range listed on the top of shock rocker and measure the distance be-
tween the shock shaft seal and the O-ring with a metric ruler or tape measure. Make sure you’re measuring the distance from the bottom of the shock seal, to the top
of the o-ring.
Sentinel 20mm w / ruler
6. If your reading is more than the suggested range, add some air to the shock. If your reading is less than the
suggested range, you need to remove some air from the shock.
ADJUST YOUR SHOCK SAG
1. Thread your shock pump onto the shocks Schrader valve port. If using a digital pump, make sure to turn it on prior to installing. If your reading was anywhere less
than the recommended setting, you need to remove a bit of air. If your sag was only slightly off, 5-10 PSI may be enough. If you’re way off, you may need to work in
larger increments from 20-50 PSI. If you need to release air, use the button by the pressure gauge to slowly let air escape.
Содержание GIDDYUP 2.OHH
Страница 1: ...GiddyUp 2 Ohh Suspension Setup Guide...
