File name: Documento1
Last modify: 2021-04-16
Document Ref: MDTECH001
Page 8 of 8
I
f the crimping diameter is not within the range of tolerance for that particular hose type, cut the hose
end and repeat the crimping operation.
To have verification of correct crimping, carry out a check with a vernier.
•
Measure the diameter of the second and third rings of the swaged ferrule and
check that the value is included in the crimping dimensional tolerance of ± 0,1mm
(see table number 1 - page 5).
•
During this measurement rotate the hose end so that you can verify if the
machine is making a proper round crimping.
Measurement of the third ring of the ferrule
Measurement of the second ring of the ferrule
WARNING!
WHEN ASSEMBLING AN ELBOW FEMALE DO NOT MOVE NOR ROTATE IT,
OTHERWISE YOU RISK TO DAMAGE OR EVEN BREAK THE INSERT INSIDE THE
HOSE COMPROMISING THE ENTIRE HOSE ASSEMBLY.
