Transcriptors Skeleton Turntable, Руководство пользователя

Страница: 13 / 20

SET UP INSTUCTIONS FOR THE
TRANSCRIPTOR TONE-ARM
(See Drawings A and B on Pages 16 and 17)
If the Transcriptor Vestigial Tone-Arm is being mounted
on other than the Transcriptor Skeleton Turntable, use
the template provided to determine the mounting
position on your base. It is imperative that your
Turntable be absolutely level before attempting any of
the adjustments. Also, note additional directions on the
template.
Alignment of the Tone-Arm involves five different
adjustments: 1. Overhang adjustment, 2. Horizontal
adjustment, 3. Height adjustment, 4. Overshoot and
anti-skating adjustment and 5. Tracking force
adjustment. Each step is detailed below. Please read
each step completely before attempting the adjustment.
I. OVERHANG ADJUSTMENT: Place a less valuable
record on the turntable and place the template provided
on the center post and position the stylus as shown in
the picture. If the arm height is low, preventing the arm
from swinging over the record, loosen the height
adjustment screw (7) on the base nut (6) and raise the
arm to a point where the arm tube is approximately 1"
(25mm) above the record surface. A more exacting
height adjustment will be made later. Rotate the Arm
mounting disc so the line (33) scribed on the top of the
cartridge platform (23) is parallel with the lines on the
template. Once the arm is adjusted, the lower base nut
(8) may be tightened finger-tight. The ground wire
located underneath the arm mounting disc should be
attached to the ground screws (9) on the lower base
nut. Resecure the three thumb nuts holding the arm
mounting disc.
- 12 -