•
Ensure that the reader is switched on and in data mode(
#00
). Enter command
#8110
to enable
the check tag.
Reader response: #============= 00
•
Switch off reader.
9. Turn the antenna upside down on top of the template to protect the cover from being scratched.
Attach the connector enclosure cover to the connector base plate using twelve 10-32 x .188-in
shoulder screws (
).
10. Apply liquid thread locker to all screw threads. Tighten each screw until its shoulder bottoms out
against the baseplate and secure to torque of 20 in-lb.
Fastening Antenna to Track Bed
After you have secured the antenna connections as specified in
, follow the steps below to fasten the antenna to the track bed.
1. Lift the antenna from on top of the template.
2. Remove the template from the antenna location and place antenna right side up (radome facing
up) on template.
3. Assemble the washer and nut on the wedge anchor stud so that the nut rests below the
chamfered head.
Figure 5 Components and Foot Blocks with Isolators on Antenna underside
AA-3233 Subway Rail Antenna
10
