Copyright © 1999 Trango Systems, Inc. All rights reserved.
12
INTERFERENCE
If interference such as lines in the pictures is observed, changing the transmission
channel may cure the problem.
Also, AC generators in close proximity to the transmitter or receiver may cause lines
in the picture. Move the unit away from the source of the interference.
NO PICTURE
Check that the transmit and receive channels are set the same, and make sure the
transmitter is not in Standby mode (slow, blinking LED), or that the battery is not
low (fast, blinking LED).
Verify all connectors are tight.
POOR PICTURE QUALITY
Raise transmitter and receiver antennas above ground and away from obstacles and
traffic, including foot traffic.
Use an optional high-gain dish antenna on the receiver. Verify all connectors are
tight. Shorten the receiver antenna feed cable.
VIDEO TOO DARK
Make sure that any monitors/peripheral equipment connected to the video source are
set to high impedance termination since the VTX2400 has a built-in 75
Ω
termination.
VIDEO TOO BRIGHT
Make sure that the receiver video output line is terminated with 75
Ω
.
CAN’T COMMUNICATE WITH TRANSMITTER OR RECEIVER USING
TRANGOLINK
Perform a system reset by holding toggle switch down while applying power. All
memory locations will be erased and the system will be reinitialized. All LEDs will
light up to indicate a successful reset. Release the toggle switch.
