Trane Voyager Commercial, Инструкция по установке, эксплуатации и обслуживанию

Страница: 120 / 156

120 RT-SVX34R-EN
Before completing the following checks, turn the unit
O
OF FF F and lock the main power disconnect switch open.
☐ Inspect the unit air filters. If necessary, clean or
replace them.
☐ Check supply fan motor bearings; repair or replace
the motor as necessary.
☐ Check the fan shaft bearings for wear. Replace the
bearings as necessary.
N No otte e:: These bearing are considered permanently
lubricated for normal operation. For severe
dirty applications, if relubrication becomes
necessary, use a lithium based grease. See
Table 69, p. 120 for recommended greases.
IIm mp po orrtta an ntt:: The bearings are manufactured using a
special synthetic lithium-based grease
designed for long life and minimum
relube intervals. Over lubrication can be
just as harmful as not enough.
☐ Use a hand grease gun to lubricate these bearings;
add grease until a light bead appears all around the
seal. Do not over lubricate!
☐ After greasing the bearings, check the setscrews to
ensure that the shaft is held securely. Make sure
that all bearing braces are tight.
☐
Inspect both the main unit control panel and heat
section control box for loose electrical components
and terminal connections, as well as damaged wire
insulation. Make any necessary repairs.
☐ Gas units only - Check the heat exchanger(s) for any
corrosion, cracks, or holes.
☐ Check the combustion air blower for dirt or
blockage from animals or insects. Clean as
necessary.
N No otte e:: Typically, it is not necessary to clean the gas
furnace. However, if cleaning does become
necessary, remove the burner plate from the
front of the heat exchanger to access the
drum. Be sure to replace the existing gaskets
with new ones before reinstalling the burner.
☐
Open the main gas valve and apply power to the
unit heating section; then initiate a “Heat” test
using the startup procedure described in
“Gas Heat
Units,” p. 105 .
W WA AR RN NIIN NG G
H Ha azza arrd do ou uss G Ga asse ess a an nd d F Flla am mm ma ab blle e
V Va ap po orrss!!
F Fa aiillu urre e tto o o ob bsse errv ve e tth he e ffo ollllo ow wiin ng g iin nssttrru uccttiio on nss
cco ou ulld d rre essu ulltt iin n e ex xp po ossu urre e tto o h ha azza arrd do ou uss g ga asse ess,,
ffu ue ell ssu ub bsstta an ncce ess,, o orr ssu ub bsstta an ncce ess ffrro om m
iin ncco om mp plle ette e cco om mb bu ussttiio on n,, w wh hiicch h cco ou ulld d rre essu ulltt iin n
d de ea atth h o orr sse erriio ou uss iin njju urry y.. T Th he e sstta atte e o off C Ca alliiffo orrn niia a
h ha ass d de ette errm miin ne ed d tth ha att tth he esse e ssu ub bsstta an ncce ess m ma ay y
cca au usse e cca an ncce err,, b biirrtth h d de effe eccttss,, o orr o otth he err
rre ep prro od du uccttiiv ve e h ha arrm m..
IIm mp prro op pe err iin nsstta alllla attiio on n,, a ad djju ussttm me en ntt,, a alltte erra attiio on n,,
sse errv viicce e o orr u usse e o off tth hiiss p prro od du ucctt cco ou ulld d cca au usse e
fflla am mm ma ab blle e m miix xttu urre ess o orr lle ea ad d tto o e ex xcce essssiiv ve e
cca arrb bo on n m mo on no ox xiid de e.. T To o a av vo oiid d h ha azza arrd do ou uss g ga asse ess
a an nd d fflla am mm ma ab blle e v va ap po orrss ffo ollllo ow w p prro op pe err
iin nsstta alllla attiio on n a an nd d sse ettu up p o off tth hiiss p prro od du ucctt a an nd d a allll
w wa arrn niin ng gss a ass p prro ov viid de ed d iin n tth hiiss m ma an nu ua all..
☐ Verify that the ignition system operates properly.
Table 69. Grease recommendations
Recommended Grease
Recommended Operating
Range
Exxon Unirex #2
Mobil 532 -20 F to 250 F
Mobil SHC #220
Texaco Premium RB
Coil Cleaning
Regular coil maintenance, including annual cleaning
enhances the unit’s operating efficiency by minimizing
the following:
• Compressor head pressure and amperage draw
• Water carryover
• Fan brake horsepower
• Static pressure losses
At least once each year—or more often if the unit is
located in a “dirty” environment—clean the
evaporator, microchannel condenser, and reheat coils
using the instructions outlined below. Be sure to follow
these instructions as closely as possible to avoid
damaging the coils.
M Ma aiin ntte en na an ncce e