TTKSVN001-EN
© American Standard Inc.2000
General Information
Introduction
This Installation Manual is given as
a guide to good practice in the
installation by the installer of mini-
split system. Installation
procedures should be performed in
the sequence that they appear in
this manual.
For installing the unit to operate
properly and reliably, it must be
installed in accordance with these
instructions. Also, the services of a
qualified service technician should
be employed, through the
maintenance contract with a
reputable service company.
Read these Installation Manual
completely before installing the
condensing unit.
About the Unit
The units are assembled, pressure
tested, dehydrated, charged and
run tested before shipment. The
information contained in this
manual applies to units that are
designed to operate in cooling only
mode.
Important
This document is customer
property and is to remain with unit.
Please place in service information
pack upon completion of work.
These instructions do not cover all
variations in systems, nor do they
provide for every possible
contingency to be met in
connection with installation.
Should further information be
desired or should particular
problems arise which are not
covered sufficiently in this manual,
the matter should be referred to
your Trane sales representative.
Reception
On arrival, inspect the unit before
signing the delivery note. Verify
that the nameplate data matches
the date on the sales order,
submittal data and delivery note
(including electrical data) to insure
the proper unit was shipped.
Specify any damage of the unit on
the delivery note, and send a
registered letter of protest to the
last carrier of the goods within 72
hours of delivery. Notify the dealer
at the same time. The unit should
be totally inspected within 7 days
of delivery. If any concealed
damage is discovered, send a
registered letter of protest to the
carrier within 7 days of delivery
and notify the dealer.
Warranty
Warranty is based on the general
terms and conditions by country.
The warranty is void if the
equipment is modified or repaired
without the written approval of The
Trane Company, if the operating
limits are exceeded or if the control
system or the electrical wiring is
modified. Damage due to
inappropriate installation, lack of
knowledge or failure to comply
with the manufacturer’s
instructions, is not covered by the
warranty obligation. If the installer
does not conform to the rules
described in Installation Manual, it
may entail cancellation of warranty
and liabilities by The Trane
Company.
Storage
Take precautions to prevent
condensate from forming inside
the unit’s electrical board and
motors if the unit is stored before it
is installed.
The Trane Company will not
assume any responsibility for unit
damage resulting from condensate
accumulation on the unit’s
electrical and/or mechanical
components.
About this Manual
Cautions and warnings appear at
appropriate places in this
instruction manual. Your personal
safety and the proper operation of
this machine require that you
follow them carefully.
The Trane Company assumes no
liability for installations or servicing
performed by unqualified
personnel. All phases of the
installation of this air conditioning
system must conform to all
national, provincial, state and local
codes.
Warning
Warnings are provided at
appropriate places in this manual
to indicate to installers, operators
and service personnel of
potentially hazardous situations
which, if not avoided, COULD
result in death or serious injury.
Caution
Cautions are provided at
appropriate places in this manual
to indicate to installers, operators,
and service personnel of
potentially hazardous situations
which, if not avoided, MAY result in
minor or moderate injury or
malfunction of the unit.
Layout
14/1/03, 10:16 AM
2
Black
