26
TK 56460-19-OP-EN
–
Bump the On/Off button three times to enter the Selectable Settings
Mode.
–
Press the On/Off Button for 5 seconds to clear the alarms. The alarm
icon should turn off. If the alarm condition still exists the alarm will
reoccur.
–
Bump the On/Off button three additional times to exit the Selectable
Settings Mode.
•
H
HM
MII D
Diim
m:: The brightness of the HMI display LEDs can be changed.
–
The TriPac Envidia system is on.
–
Bump the On/Off button three times to enter the Selectable Settings
Mode.
–
Rotate the Fan Speed knob to change display brightness.
–
Bump the On/Off button three additional times to exit the Selectable
Settings Mode.
•
S
Sh
ho
orre
e P
Po
ow
we
err C
Ch
ha
arrg
giin
ng
g:: Available if the optional AC to DC Shore Power
Converter is installed and plugged-in to an external 115 Vac source. Can
be used to charge system batteries while TriPac Envidia and truck
systems are off. Taking no action will charge only the truck batteries. The
driver may manually select to allow the TriPac Envidia system to
immediately switch to charge mode if truck battery voltage is above 13
Vdc. Shore Power Charging must be selected each time the feature is
desired.
N
No
otte
e:: If the system is turned Off at the HMI, after a 15 minute delay the
system will automatically sense if Shore Power is connected. It will
allow the TriPac Envidia batteries to charge if System Voltage rises
above 13.5 Vdc.
–
Turn the truck ignition and TriPac Envidia system off.
–
Bump the On/Off button once to activate the System Status Display.
–
Bump the On/Off button three times to enter the Selectable Settings
Mode.
–
Bump the On/Off Button an additional two times to toggle the feature.
–
Bump the On/Off button three additional times to exit the Selectable
Settings Mode.
–
After about 20 seconds the green Battery Monitor bars should begin
to scroll up. This indicates the TriPac Envidia system is in charge
mode. Refer to Battery Charging in this section.
