Trane P0V0 Series, Руководство по установке

Страница: 13 / 36

18-GE20D1-1E-EN 13
General Installation
The following sections give general instructions for the
installation of the modular blowers.
Panel Removal
Note: For the P0V0, a 1/4" nut driver is required to remove the two
screws at the top of the front panel. The front panel can then be
removed by lifting upwards.
Note: Tinnerman clips are provided in the doc pack if the door panel
flange hole(s) becomes stripped.
Note: Remove shipping bracket before installation.
Tinnerman clip locations
(if needed)
Shipping bracket
Horizontal Installation in an Attic
or Crawlspace
The modular blower may be installed in an attic or
crawl space in the horizontal position by placing it on
its left or right side (as viewed from the front in the
vertical position). The horizontal installation in an attic
should be on a service platform large enough to allow
for proper clearances on all sides and service access to
the front of the modular blower. See
“Location and
Clearances,” p. 6 . Line contact is only permissible
between lines formed by intersections of the top and
two sides of the modular blower casing and building
joists, studs, or framing.
The modular blower may be placed horizontally in a
crawl space on a pad or other noncombustible
material. Place blocks underneath to support the
modular blower and raise the unit for sufficient
protection from moisture.
The modular blower may be installed hanging in a
hanging position using straps. The modular blower
should be supported at both ends and have an
additional support in the center of the modular blower
in back.
WHEN SUSPENDING THE HORIZONTAL
MODULAR BLOWER, IT SHOULD BE
SUSPENDED BY ATTACHING TO THE
CABINET IN THE PLACES SHOWN.
WHEN SUPPORTING THE
MODULAR BLOWER FROM
BELOW, SUPPORT FRONT
TO BACK (AS SHOWN)
OR SIDE TO SIDE.