background image

Page 2

INSTALLER'S GUIDE

Section 1. Safety Considerations 

SAFETY HAZARD! 

All joints must be leak free.   Seal per local and national codes.

CAUTION

SAFETY HAZARD! 

Sharp Edge Hazard. Be careful of 

sharp edges on equipment or any cuts made on sheet metal while 

installing or servicing. Personal injury may result.

CAUTION

1.1  WARNINGS

IMPORTANT:  Read this manual carefully before attempting to install, 

operate, or perform maintenance on this hydronic coil.  Installation, 

service, and maintenance should be performed by qualified technicians 

only. 

NOTE:  “Warnings” and “Cautions” appear at appropriate places in this 

manual.  Read these carefully.  Your personal safety and the proper 

operation of this heating product require that you follow them carefully.  

The manufacturer assumes no liability for installations or services 

performed by independent dealers. 

 

Safety signal words are used to designate a degree or level of serious-

ness associated with a particular hazard.  The signal words for safety 

markings are WARNING and CAUTION.

WARNING indicates a potentially hazardous situation which, if not 

avoided, could result in property damage, death or serious personal 

injury.

CAUTION

!

CAUTION indicates a potentially hazardous situation which, if not 

avoided, may result in minor or moderate injury. It is also used to alert 

against unsafe practices and hazards involving only property damage. 

s

s

WARNING

THE INFORMATION IN THIS GUIDE IS FOR USE BY INDIVIDUALS 

HAVING ADEQUATE ELECTRICAL AND MECHANICAL BACK-

GROUND.  ANY ATTEMPTS, BY UNQUALIFIED PERSONS,  AT 

PLUMBING, INSTALLING OR REPAIRING A HYDRONIC SYSTEM 

OR CENTRAL AIR CONDITIONING PRODUCT COULD RESULT IN 

PROPERTY DAMAGE, SEVERE PERSONAL INJURY OR DEATH.  

THE MANUFACTURER OR SELLER CANNOT BE RESPONSIBLE 

FOR THE INTERPRETATION OF THIS INFORMATION, NOR CAN IT 

ASSUME ANY LIABILITY IN CONNECTION WITH ITS USE.

s

s

WARNING

ELECTRICAL HAZARD! 

DISCONNECT ALL ELECTRICAL POWER, INCLUDING REMOTE 

DISCONNECTS BEFORE INSTALLING OR SERVICING.  FOLLOW 

PROPER LOCKOUT/TAGOUT PROCEDURES TO ENSURE THE 

POWER CAN NOT BE INADVERTENTLY ENERGIZED.  FAILURE TO 

FOLLOW THIS WARNING COULD RESULT IN SERIOUS PERSONAL 

INJURY, DEATH, OR PROPERTY DAMAGE. 

s

s

WARNING

HIGH PRESSURE HAZARD! 

MAXIMUM ENTERING WATER TEMPERATURE IS 180°F.  WATER 

TEMPERATURES EXCEEDING 180°F COULD CAUSE A HIGH 

PRESSURE BURST.  FAILURE TO FOLLOW THIS WARNING COULD 

RESULT IN SERIOUS PERSONAL INJURY, DEATH, OR PROPERTY 

DAMAGE. 

s

s

WARNING

SCALD HAZARD! 

 

THIS SYSTEM CONTAINS HOT WATER AND OPERATES UNDER 

PRESSURE.  WATER TEMPERATURES ABOVE 125°F CAN INSTANT-

LY CAUSE SEVERE BURNS OR DEATH.  

USE CAUTION WHEN SERVICING THIS EQUIPMENT.  ALLOW SUF-

FICIENT TIME FOR THE WATER TO COOL BEFORE OPENING THE 

SYSTEM DRAIN.  FAILURE TO FOLLOW THIS WARNING COULD 

RESULT IN SERIOUS PERSONAL INJURY, PROPERTY DAMAGE, OR 

DEATH. 

s

s

WARNING

LEAK HAZARD! 

 

IF THE HYDRONIC COIL HAS A LEAK, USE CAUTION WHEN 

SERVICING THIS EQUIPMENT.   THOROUGHLY WIPE OFF EXCESS 

WATER FROM ALL COMPONENTS AND ALLOW ADEQUATE TIME 

FOR THE COMPONENTS TO DRY COMPLETELY BEFORE SERVIC-

ING SYSTEM.  

FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS 

PERSONAL INJURY, PROPERTY DAMAGE, OR DEATH. 

1.2  CAUTIONS

s

s

WARNING

SAFETY HAZARD! 

REMOVE ANY ELECTRICAL STRIP HEATERS WHEN INSTALLING 

THE HYDRONIC HEATER COIL.  ELECTRICAL AND HYDRONIC 

HEAT MUST NOT BE USED TOGETHER.  FAILURE TO FOLLOW 

THIS WARNING COULD RESULT IN SERIOUS PERSONAL INJURY, 

DEATH, OR PROPERTY DAMAGE. 

FREEZE HAZARD! 

Installations subject to freezing 

ambient temperatures must have provisions for freeze protection to 

avoid damage to this appliance.  

CAUTION

SAFETY HAZARD! 

The selected location and orientation 

of the air handler and hydronic coil must allow the hydronic heating 

unit's circulator pump to be positioned with the motor shaft horizon-

tal.  Do Not install the hydronic coil with its service panel and the 

circulator pump facing vertical, up, or down.

CAUTION

s

s

WARNING

Содержание BAYWACC11SC1AA









Отзывы: