Trane BAY24X042, Руководство по установке

Страница: 10 / 24

Installation
10 ACC-SVN67M-EN
11. Secure the electric heater element assembly with the
necessary amount of screws.
12. Slide the electric heater control panel/access door
assembly inward until the rear edge engages with retaining
clips. See
Figure 3 . For the BAYHTRS, BAYHTRT,
BAYHTRU, and BAYHTRW kits, secure the outer edge
with 2 screws. The BAYHTRA, BAYHTRB, and BAYHTRD
kits will secure the control panel with screws at the top
against the vestibule panel and against the indoor divider
panel. See
Figure 7 .
13. To install the hinged door stops, loosen one existing screw
from the upper left side of the electric heater compartment
opening. Position each door stop with outer tab flush
against center post and secure each door stop with 1 or 2
screws. See zoom view in
Figure 8 or Figure 9 .
14. Remove the wire nuts from W1, W2 and W3.
15. For models with the control box in the outdoor section,
route the wires through the wire access opening in the
divider panel, then up to the unit control box entering
through the bottom wire access opening on the left side.
See
Figure 8 . For models with the control box above the
heat exchanger section, route the wires through the hole in
the panel separating the heater compartment and the
control box compartment. See
Figure 9 . Secure wires to
the existing harness.
Figure 6.
Figure 7.
LOCATOR TABS
SCREWS NOT
REQUIRED ALONG
THE TOP
SCREWS
FILLER PANEL
SCREWS
Screws
Figure 8. Single point power
Figure 9.
CC1 CC1
ROUTE WIRES ROUTE WIRES
THROUGH
THROUGH
THE HOLE IN THE
THE HOLE IN THE
PANEL
PANEL
HINGED DOOR STOP HINGED DOOR STOP