54
CVHE-SVX005B-EN
Figure 34.
Display attachments to the support arm
base plate
E
Adjusting the Tracer AdaptiView
Display Arm
The Tracer
®
AdaptiView
™
display arm may become
too loose or too tight and may need adjustment. There
are three joints on the display arm that allow the
display to be positioned at a variety of heights and
angles (refer to items labeled 1
1, 2
2, and 3
3 in the
following figure).
Figure 35.
Joint locations on the display arm
1
2
3
4
To adjust the tension on the display arm:
•
At each joint in the display arm, there is either a hex
bolt (1
1 and 2
2) or hex screw (3
3). Turn the hex bolt or
screw in the proper direction to increase or
decrease tension.
N
No
otte
e:: Each hex bolt or screw is labeled with
llo
oo
osse
en
n/ttiig
gh
htte
en
n or +
+/-- indicators.
•
Joint 3
3 has a 6 mm hex screw controlling the
tension on a gas spring, which allows the Tracer
®
AdaptiView
™
display to tilt up and down.
•
Joints 1
1 and 2
2 are covered by a plastic cap. Remove
the plastic cap to access the screw. Adjust using a
13 mm wrench as necessary.
•
To adjust the swivel rotation tension of the Tracer
AdaptiView display, adjust the screw located in the
support arm base plate, as described in the final
step in the Installing the Tracer AdaptiView Display
section..
This adjustment must be done prior to
attaching the display to the support arm base.
Use a
14 mm wrench to adjust the tension.
•
To adjust the left/right swivel of the entire display
arm, use a 13 mm wrench to adjust the screw
labeled 4
4 in the preceding figure.
