TEF 2438N
LUMINAIRE USER MANUAL
INTRODUCTION
Thank you for purchasing this product!
For installation, maintenance and assurance of a long life
of this product, please follow this manual.
CONTENT IN BOX
The product is fully assembled, and ready for installation.
SAFETY PRECAUTIONS
Note that changes made to the product and/or
installation of components which do not conform to the
approval, may be a safety violation. The manufacturer will
in no circumstance be held responsible for such activity.
For your health and safety, always use safety gear suited
for the task. Be certain to follow codes, regulations and/or
specific procedures that are related to the installation.
TOOLS REQUIRED
Regular tools required for installation:
•
10 mm wrench –for assembling the luminaire.
•
27 mm wrench –for cable gland.
•
24 mm wrench –for pressure nut on the cable gland
•
4 mm flat screwdriver –for assemble and disassemble
the plate w/lamp holder 2438 without economizer bulb.
•
5,5 mm flat screwdriver –for earth screw.
MAINTENANCE INSTRUCTIONS
The luminaire should be inspected according to Company
routines. The manufacturer suggests regular check for
water intrusion/condensation which should be removed
immediately. Check the drain plug / drain hole function.
When cleaning, use only mild detergents. Alcohol or
petroleum based products may damage lens, paint or
plastic components.
APPLICATIONS
•
Deck lighting
•
Signal lighting
•
Obstacle marking
•
Perimeter lights on helideck
•
For use in safe areas
•
General lighting
RUBBER SEAL
Cable diameter
Size
Part No.
5 - 9mm
Ø20,4/9 x 8mm
5002 0045
8,5 - 14mm
Ø20/13 x 8mm
5002 0038
Be sure to install the cable in a way wich prevents water to penetrate into the enclosure through the cable gland,
also make sure to use the correct rubber seal when you install the luminaire.
APPROVAL
NA
