How to install the Immobilizer
T22-IMMOBILIZERMAN 2.5
© Tramigo Ltd. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form
without the prior written permission of Tramigo.
Page 4
1. Configure your T22 for Immobilizer feature with SOS button.
Send the following commands via SMS or Tramigo Manager to your T22 which will have the
immobilizer feature:
•
set,input2,1
•
set,input1,4
•
set,HFMinPressTime,1
•
set,SOSMinPressTime,5000
•
set,IgnitionInputGPIO,1
•
set,IgnitionInputShock,0
Tip: If you are installing many T22’s save these messages in your phone.
2.
X & Y
connect to
GND
.
(You can join the 2 small black wires and use a single wire to GND.)
Make sure it is connected to the chassis of vehicle, and not to any assumed GND.
3.
Cut the wire that activates the starter when Ignition is switched ON. Connect the
GREEN
and
the
YELLOW
immobilizer wires on the cut wires respectively.
When you cut the Ignition cable/wire
into two, test one end with multitester
(or even bulb), the side that gives
voltage or lights up is for the
GREEN
wire and the other side staying blank
is for the
YELLOW
wire.
4.
Tap the
BLUE
wire to the Ignition line. This line should have the power ON always when the
engine is running.
5. RED Wire (which has 15A fuse attached to it), connects directly to the vehicle power.
This can be the same to which T22-CAR red (positive) wire is connected.
NOTE:
RED WIRE can be also connected to IGNITION to extend relay lifetime and to reduce
power consumption
6
.
X
wire and
BROWN
wire are connected to an extra input (SOS / Sensor / ATB button) which is
optional.
