IQL 4G VEHICLE TRACKER USER MANUAL
9
5.1.
Switching on the Backup Battery
To use the IQL 4G VEHICLE TRACKER backup battery, the switch must be at the ON
position. The switch and the ON/OFF position are shown as below.
Figure 7. Switch ON/OFF Position
Note:
1.
The switch must be at the “OFF” position when the IQL 4G VEHICLE TRACKER is being
shipped on an aircraft.
2.
When the switch is at the “OFF” position, the battery cannot be charged or discharged.
5.2.
Power Supply Connection
VIN (pin 3)/GND (pin 7) are the power input pins. The input voltage range for this device
is from 8V to 32V. The device is designed to be installed in vehicles that operate on
12V/24V systems without the need for external transformers.
DC Power
GND
Figure 8. Typical Power Connection
5.3.
Ignition Detection
IGN (pin 4) is used for ignition detection. It is recommended to connect this pin to the
“RUN” position of the vehicle ignition switch as shown below.
An alternative to connect to the ignition switch is to find a non-permanent power source
that is only available when the vehicle is running. For example, the power source for the
OFF
ON
5. Getting Started
