Replacing the Tip
1. Turn off, unplug, and allow the iron to cool to room temperature.
2. Loosen and remove the retaining nut.
3. Remove the tip holder.
4. Remove and dispose of the old tip.
5. Wipe the threaded section of the iron and the
retaining nut with a dry rag.
6. Install the new tip, holder, and retaining nut. The nut should only be tightened to fi nger tight.
7. Plug in and turn on the iron. When it reaches the desired temperature, wipe the new tip clean on the cleaning sponge
and tin it with fresh solder.
Error Messages
- - - = System Error
After the power has been turned on, the system checks the memory and the programs. If an abnormality is found,
- - -
will be displayed and all operation will be completely stopped.
S – E = Sensor Error
If there is a possibility of a failure in the sensor or anywhere in the sensor circuit,
S – E
will be displayed and power to
the soldering iron will be cut off.
Flashing of temperature display = Heater Error
If power is being sent to the soldering iron and the tip temperature falls below the heater error temperature tolerance, the
temperature display will fl ash. This indicates a possible heater malfunction. Example: The temperature is set to 400°C
and the heater error temperature tolerance is set to 50. If the tip temperature drops below 350°C while power is being
sent to soldering iron, the display will begin to fl ash indicating a possible heater malfunction.
Parts
Replacement
TKPR0960
TrakPower Replacement 908 Iron
TKPR0965
TrakPower A1042 Sponge
TKPR0968
TrakPower Chisel Tip 3.2 mm
TKPR0969
TrakPower Chisel Tip 2.4 mm
TKPR0970
TrakPower Pencil Tip 1.0 mm
Optional
TKPR0975
TrakPower Rosin Core Lead Free Silver Solder 15 g
TKPR0976
TrakPower Rosin Core Silver Solder 100 g
TKPR1015
TrakPower Cleaning Wire with Holder
TrakPower warrants this product to be free from defects in materials and workmanship for a period of 5 years on the base unit and 1 year on the
iron handle from the date of purchase. During that period, TrakPower will, at its option, repair or replace without service charge any product deemed
defective due to those causes. You will be required to provide proof of purchase (invoice or receipt). This warranty does not cover damage caused by
abuse, misuse, alteration or accident. If there is damage stemming from these causes within the stated warranty period, TrakPower will, at its option,
repair or replace it for a service charge not greater than 50% of its then current retail list price. Be sure to include your daytime telephone number in
case we need to contact you about your repair. This warranty gives you specifi c rights. You may also have other rights, which vary from state to state.
For service on your TrakPower
product, warranty or non-warranty,
send it post-paid and insured to:
HOBBY SERVICES
3002 N. Apollo Drive Suite 1
Champaign, IL 61822
(217) 398-0007
[email protected]
TKPR0955
TIP
RETAINING NUT
THREADS
THREADS
TIP HOLDER
