TRAK RACER TR80, Руководство пользователя

Страница: 6 / 18

6
STEP 5
Add the seat slider and brackets as shown below.
Additional information on this step can be found on page 18
.
After fitting the leaver, test if the rails can slide easily without any rubbing.
Note:If you are a tall person its advised to mount the rails as shown below. If you are
short person its advised to mount the rails on the most forward end of the profile.
Start with placing the rails with the flat side upwards and the metal protrusions facing
inwards. The leaver should be pulled upwards to unlock the rails.
Now slightly fasten the front bolt of the rails just enough to keep it in position but
allow the rails to swivel at the back slightly to align the back bolt without any tension.
Now use a screwdriver (or the leaver) on the metal protrusions on the inside to slide
the rails forward to gain acces to the back bolt, now fully tighten the back bolt.
If that bolt is tightend slide the rails backwards again to regain acces to the front bolt
and fully tighten it. After fully tightening the rails, bring the rails back to the neutral
position and mount the other side in the same way.
After both rails are in neutral position and tightend, its time to add the leaver.
The leaver needs to be bend outwards a bit further than the actual width of both rails.
Now place one side with the holes in the protrusions with the other side just above
the rails and apply a bit of force inwards to overcome the resilience, now allign the
leaver with the other end of the rails protrusions.
If the leaver is placed and it unlocks/locks the rails correctly continue mounting the
seatbrackets.