www.
TrailFX
.com
Page
1
of
4
Rev 051418
EXCLUDES SXT MODEL
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER
TORQUE
.
STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM
45
TO
65
FOOT POUND.
30-60 min
1 866 638 4870
POLISHED STAINLESS STEEL
– LIMITED LIFETIME
POWDER COATED BLACK
– 3 YEARS
Cutting Not
Required
PARTS LIST:
Qty
Part Description
Qty
Part Description
1
Driver/Left Sidebar
6
12mm Serrated Flange Nuts
1
Passenger/Right Sidebar
12
8-1.25mm x 25mm Hex Bolts
3
Driver/Left Mounting Brackets
12
8mm x 24mm x 2mm Flat Washers
3
Passenger/Right Mounting Brackets
12
8mm Lock Washers
6
12-1.75mm x 40mm T Bolts
12
6-1.0mm x 25mm Hex Bolts
6
12mm Plastic Retainers
24
6mm x 18mm OD x 1.6mm Flat Washers
6
12mm x 24mm OD x 2.5mm Flat Washer
12
6mm Nylon Lock Nuts
INSTALLATION PROCEDURE
1.
Starting along the driver side of the vehicle, locate the 3 pairs of (2) small factory holes in the pinch weld,
(Figure 1)
.
Remove the rubber plug filling the oval hole in the bottom of the rocker panel directly in front of the (2) holes,
(Figure 1)
.
2.
Select (1} 12mm Bolt Plate and (1} 12mm Plastic Retainer,
(Figure 2A).
Thread the Retainer part way onto the Bolt Plate.
NOTE:
The Retainer will help hold the Bolt Plate in position during Bracket installation. Insert the Bolt Plate into the hole and
rotate 90-degrees to the slot,
(Figures 28
& 3). Thread the Retainer down until it is tight against the sheet metal.
3” Side Bar
Part No.
A0025S/B
Fits:
2011 -
Current
Dodge Durango 4DR.
Drilling Not
Required
Содержание NERF BAR A0025S
Страница 3: ...Page 3 of 4 Rev 051418 www TrailFX com...
