www.TrailFX.com
Page
2
of
4
Rev 051418
3.
Select (1} driver side Mounting Bracket and hang it from the Bolt Plate with (1} 12mm Flat Washer and (1} 12mm Flange
Nut,
(Figures 4 & 5).
4.
Next, bolt the mounting plate on the Bracket to the front of the pinch weld with (2) 6mm x 25mm Hex Bolts, (4) 6mm Flat
Washers and (2) 6mm Nylon Lock Nuts,
(Figures 4 & 5).
Snug but do not fully tighten hardware at this time.
5.
Repeat
Steps 2- 5
for centre and rear Mounting Bracket installation.
6.
Select the driver felt Sidebar and careful y place it in position on the (3) Mounting Brackets. Line up the threaded holes in
the Sidebar with the slots in the Brackets. Bolt the Sidebar in place with the included (6) 8mm x 25mm Hex Bolts, (6) 8mm
Lock Washers and (6) 8mm Flat Washers,
(Figure
6). Snug all hardware but do not tighten at this time.
7.
Adjust and level the Sidebar and tighten all hardware.
Содержание NERF BAR A0025S
Страница 3: ...Page 3 of 4 Rev 051418 www TrailFX com...
