www.TrailFX.com
Page
2
of
4
Rev 081518
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION. ASSISTANCE IS RECOMMENDED.
1.
Start the installation under the passenger side of the vehicle. Locate the front (3) factory studs along the inner side of the body
panel,
(Figure 1)
. Use a wire brush or thread chaser die to remove excess paint or undercoating from threaded studs as
necessary.
2.
Select (1) Mounting Bracket.
NOTE
: All (6) Brackets are universal and will fit left or right side. Attach the Mounting Bracket to the
(3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts,
(Figures 2 & 3)
. Leave brackets loose at this time.
3.
Repeat
Steps 1 & 2
to install the Mounting Brackets in the center and rear mounting locations along the body panel,
(Figures
4—6)
.
4.
Carefully unwrap and select the Passenger/right Sidebar. Use the illustration above to help identify the correct Sidebar. Place the
Sidebar on top of the Brackets.
IMPORTANT
: Do not slide, (front to back or rotate), the Sidebar on the Brackets or damage to the
finish on the Sidebar may result.
5.
Attach the Sidebar to the Brackets with (6) 8mm Combo Hex Bolts,
(Figures 7—9)
. Do not tighten hardware at this time.
6.
Level and adjust the Sidebar as necessary and fully tighten all hardware.
7.
Repeat
Steps 1—6
for Driver/left Sidebar installation.
8.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Passenger/right Side Installation Pictured
Front
(Fig 1) Passenger side front mounting location
(3) 8mm Flat Washers
(3) 8mm Nylon Lock Nuts
(Fig 2) Attach Bracket to the (3) studs
Front
(Fig 4) Passenger/right center mounting location
(Fig 3) Attach Mounting Bracket to
passenger/right front location
Front
