www.TrailFX.com
Page
5
of
7
Rev 031318
5.
Move to the rear location,
(Figure 15)
. Repeat
Steps 2
—4
to install the rear Brackets,
(Figure 16)
.
NOTE
: The cradles on
the front, center and rear Brackets must all face forward.
6.
Select the driver/left Sidebar. Carefully position the Sidebar onto the (3) Mounting Brackets.
IMPORTANT
: Do not slide,
(front to back or rotate), the Sidebar on the Brackets or damage to the finish on the Sidebar may result. Attach the Sidebar
to the (3) Brackets with (6) 8mm Combination Hex Bolts,
(Figures 17
—19)
. Do not fully tighten at this time.
Rear
(Fig 15) Driver/Left rear mounting location
IMPORTANT: 2009-2012 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach driver side front
support bracket. Do complete installation of
sidebars first, level sidebar before drilling
holes for support bracket.
Rear
(Fig 16) Driver/Left rear Brackets installed
IMPORTANT: 2009-2012 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach driver side front
support bracket. Do complete installation of
sidebars first, level sidebar before drilling
holes for support bracket.
Front
(Fig 17) Driver/Left front installation
(2) 8mm Combo
Hex Bolts
Front
(Fig 18) Driver/left center installation
(2) 8mm Combo
Hex Bolts
Rear
(Fig 19) Driver/Left rear installation
(2) 8mm Combo
Hex Bolts
