www.TrailFX.com
Page
2
of
5
Rev 111016
2.
Move to the front mounting location at the bottom corner of the body. Remove the rubber plugs from the bottom and side of the
body panel as necessary,
(Figure 2)
. Select (2) 8mm Clip Nuts. Slide the Clip Nuts into the large holes and over the smaller
holes. Line up the threaded nut on the Clip Nut with smaller hole in body panel,
(Figure 3)
.
3.
Select the passenger side front Mounting Bracket. Line up the holes in the Bracket with the (2) Clip Nuts. Attach the Bracket to
the Clip Nuts with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers,
(Figure 4)
. Leave hardware loose at
this time
4.
Next, carefully pull back the plastic lower fender cover and remove the (2) factory bolts in the bottom of the fender,
(Figure 5)
.
Select the passenger front Support Bracket,
(Figure 6)
. Attach the Bracket to the (2) threaded holes with (2) 6mm x 20mm Hex
Bolts and (2) 6mm Flat Washers,
(Figure 7)
.
IMPORTANT
: Make sure the Support Bracket is behind the front Bracket. Snug
but do not fully tighten hardware at this time.
5.
Move along the side of the vehicle to the second mounting location,
(Figure 1)
. Repeat
Step 2
to install (2) 8mm Clip Nuts in
the (2) factory holes in the body panel,
(Figure 7)
. Select (1) Center Bracket.
NOTE
: Center Bracket can be installed on either
the driver or passenger side. Bolt the Mounting Bracket to the (2) Clip Nuts with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and
(2) 8mm Flat Washers,
(Figure 8)
. Snug but do not fully tighten the hardware.
6.
Skip the third mounting location and move to the last location at the back of the cab,
(Figure 9)
. Repeat
Step 4
to install the
passenger side rear Mounting Bracket,
(Figure 10)
.
7.
Select the passenger/right Sidebar. Carefully position the Sidebar up to the front and rear Mounting Brackets. Attach the
Sidebar to the Mounting Brackets with (2
) 1/2” x 2” Hex Bolts, (2) 1/2” Lock Washers, and (2) 1/2” Flat Washers,
(Figures 10 &
12)
. Snug but do not tighten at this time.
8.
Move to the Center Bracket. Line up the Bracket with the threaded inserts in the bottom of the Sidebar. Attach the Sidebar to
the Bracket with (2) 8mm x 25mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers,
(Figure 11)
. Do not tighten
hardware.
9.
Level and adjust the Sidebar and tighten all hardware.
10.
Repeat
Steps 1
—9
to install the driver/left Sidebar.
11.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Passenger/right Side Installation Pictured
Front
(Fig 3) Slide 8mm Clip Nut into large hole and over
small hole. Passenger front location pictured
(Fig 1) Locate passenger side mounting
locations along bottom and back of body panel
Front
8mm Clip Nuts
(Fig 2) Remove plugs from all (3) locations
