www.TrailFX.com
Page
1
of
5
Rev 111016
PARTS LIST:
Qty
Part Description
Qty
Part Description
1
Driver/left Sidebar
4
1/2" x 2” Hex Bolts
1
Passenger/right Sidebar
4
1/2” x 1-1/4” OD x 3/32” Flat Washers
1
Driver/left Front Mounting Bracket
4
1/2” Lock Washers
1
Passenger/right Front Mounting Bracket
12
8mm Clip Nuts
1
Driver/left Front Support Bracket
16
8-1.25mm x 25mm Hex Bolts
1
Passenger/right Front Support Bracket
16
8mm x 24mm OD x 2mm Washer
2
Center Brackets (use left or right)
16
8mm Lock Washers
1
Driver/left Rear Mounting Bracket
4
6-1.0mm x 20mm Hex Bolts
1
Passenger/right Rear Mounting Bracket
4
6mm x 18mm OD x 1.6mm Flat Washers
PROCEDURE:
1.
Start the installation under the passenger side of the vehicle. Locate the 4 factory running board mounting locations along the
bottom and inner side of the body,
(Figure 1)
. Mounting Brackets will bolt to the 1st, 2nd and 4th mounting locations.
NOTE
: It
may help to hold a Bracket up in place to help determine the mounting holes to use along the bottom and inner side of the
body.
`
3" Nerf Bar
Part No. A0037S/B
Fits:
2015 - Current Chevrolet Colorado Extended Cab
2015 - Current GMC Canyon Extended Cab
(2) Center Mounting Brackets (use for
driver or passenger side installation)
Example of passenger/right Sidebar-
arrow indicates insert location
Front
NOTE: Front step pad slightly
farther away from end of tube
Passenger/right rear
Mounting Bracket
Passenger/right front
Mounting Bracket
Passenger/right front
Support Bracket
Driver/left rear
Mounting Bracket
Driver/left front
Mounting Bracket
Driver/left front
Support Bracket
ASSISTANCE IS RECOMMENDED.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER
TORQUE
.
STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM
45
TO
65
FOOT POUND.
60-180 min
1 866 638 4870
POLISHED STAINLESS STEEL
– LIMITED LIFETIME
POWDER COATED BLACK
– 3 YEARS
Drilling Not
Required
Cutting Not
Required
