www.TrailFX.com
Page
4
of
6
Rev 010115
4.
Move toward the rear of the vehicle. Select the driver side Rear Mounting Bracket,
(Figure 4)
. Bolt the rear Mounting
Bracket in place as previously described in
Step 2
,
(Figure 7)
.
5.
With assistance, position the diver/left Sidebar up to the front Mounting Bracket. Determine the correct mounting hole to
use:
2014-On 1500 Double Cab
: Attach the Sidebar to the top slot in the front Bracket,
(Figures 2A & 5)
.
1999-2013 1500, 1999-2015 25-3500
: Attach the Sidebar to the bottom slot in the front Bracket,
(Figures 2A & 5)
.
6.
Attach the front and rear of the Sidebar to the Brackets with the included (2) 1/2” x 2” Hex Bolts, (2) 1/2” Lock Washers
and (2) 1/2” Flat Washers,
(Figures 5 & 7)
. Do not tighten hardware at this time.
7.
Attach the center Mounting Bracket to the Sidebar with the included (1) 8mm x 25mm Hex Bolt, (1) 8mm Lock Washer
and (1) 8mm Flat Washer,
(Figure 6)
. If the Bracket does not line up with the insert, it may be necessary to loosen the
body bolt slightly to move the Bracket. Do not tighten the 8mm hardware at this time.
8.
Level and adjust the Sidebar and tighten all hardware. Check all mounting locations for clearance between the factory
steel body mount brackets and the Mounting Brackets. Adjust Brackets if necessary and once satisfied with fit, fully
tighten all hardware.
9.
Repeat
Steps 1
—8
for passenger Sidebar installation.
10.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Front
(Fig 3C) Driver/left Center Bracket assembly as
installed on all model years (except 2014 1500)
Factory body bolt
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
(Fig 4) Driver/left rear Bracket
Front
1/2” x 2” Hex Bolt
1/2” Lock Washer
1/2” Flat Washer
Factory body bolt
(Fig 5) Driver/left front Bracket
