TrailFX A0002S, Инструкция по установке

Страница: 4 / 4

Page 4 of 4 Rev 010115
1. Hardware’s are not of correct size.
In GMC / Chevrolet truck model 2006 & up, customer needs to reuse the factory body bolts to install the bracket. If your vehicle is not
GMC / Chevrolet 2006 & up, ensure that holes are not partially covered with any plastic grommet or rust? If it is, remove the plastic
grommet & rust from the thread holes & re-try the installation.
2. Mounting Bracket are not getting Installed properly.
In some cases Illustration images shown in Installation manual may not be the exactly same as per actual vehicle images ,also if Driver /
Passenger side mounting brackets are very identical in the design, suggest referring Parts Identification guide to avoid fitment issue.
3. Products are thumping / rattling after installation.
Ensure that all required mounting brackets / hardware’s are installed & tighten correctly. Suggest using white lithium / regular grease
between the metal to metal contact surfaces.
4. Side Bar is not aligning with vehicle / Step Pads are not aligning with vehicle doors.
Side bar may be interchanged or mounting brackets are not installed at the correct position in the vehicle. Refer Parts identification guide.
5. Missing / Excess Hardware.
Recheck hardware count as per the part list.
6. Product not installing properly.
Ensure make model year, cab length and bed size of your vehicle is listed in the application. All installation steps are followed correctly.
PARTS IDENTIFICATION GUIDE
Driver Side tube taped in “Red” Color. Passenger Side tube taped in “Blue” Color.
No. Parts Identification
1
Passenger / Right ‘Rear’ Bracket marked “ RR ”
2 Driver / Left ‘Rear’ Bracket marked “ RL ”
3 Passenger / Right ‘Center’ Bracket marked “ CR ”
4 Driver / Left ‘Center’ Bracket marked “
CL
”
5 Passenger / Right ‘Front’ Bracket marked “ FR ”
6
Driver / Left ‘Front’ Bracket marked “ FL ”
7 ‘Left’ marked “ L ”
8 ‘Right’ marked “ R ”
Note:

This guide is to identify the parts and not a reference for part count.

Product / Bracket image is for representative purpose only.

Actual design may vary based on application.

Refer Parts List for Hardware.

Periodically check the product to ensure all fasteners are tight and components are intact.
 Regular waxing is recommended to protect the finish of the product.

Use ONLY Non-Abrasive automotive wax. Use of any soap, polish or wax that contains an abrasive is detrimental and can scratch the
finish leading to corrosion.
 Aluminum polish may be used to polish small scratches and scuffs for
Stainless Steel finish.

Mild soap may be used to clean the product for both
Stainless Steel and Black finish.