Trailer Valet RVR12, Руководство по эксплуатации

Страница: 10 / 16

TREAD MAINTENANCE
10
ADJUSTING TRACK TENSION
Over time, the tracks on your unit will stretch. This is expected after the first couple
uses. To tighten your track, first, loosen the retaining bolt shown below using a 14
mm socket wrench. Only a half to quarter turn is needed to loosen the bolt. DO NOT
attempt to remove the bolt.
Next, insert a wedge implement, such as a flathead screwdriver, into an exposed
tensioning notch closest to the retaining bolt.
Tighten the track by moving the notch in the direction away from the retaining bolt.
While maintaining this tension, re-tighten the retaining bolt to secure the track in
place.
REPLACING TREAD SECTION
1. Remove 2 adjacent Rotoclips from the front end of the tug. Remove 2 track pins
with the Rotoclips on the opposite end intact and 2 track links.
Tip: Tap the end of the track pin using a hammer to drive the pin through the
Rotoclip. The Rotoclip will not be reusable after.
2. Remove one track segment and
align the ends of the track.
Tap Track
Pin Here
Rotoclip and
Pin Intact
Track Link
Track Link
Discard
Rotoclips
Retaining
Bolt
Flathead
Screwdriver