Wiring Loom Fitting Instructions
To Suit Toyota Kluger MY11 – MY14
Part Number 100471-WL
Page
2 of 3
Issue Date
03-07-14
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9797 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
These following Steps for Toyota Kluger MY07 to MY13
1. In the engine bay, remove the fuse box cover.
2. From underneath the vehicle, remove the LHS rear bumper shroud by first removing all
the fasteners.
3. In the luggage compartment, fold the rear seats forward.
4. Remove the rear section of the floor cover carpet.
5. Remove the LHS & RHS outer floor cover carpet.
6. Remove the LHS storage compartment by first removing the two fasteners.
7. In the rear LHS of the luggage compartment, remove the larger front most grommet.
8. Drill out the grommet hole to Ø31mm.
9. File any rough or sharp edges and spray on rust inhibitor.
10. In the rear LHS quarter of the luggage compartment, locate the vehicle trailer 6-way
female breakout connector.
11. Connect the trailer patch connector to the vehicle trailer breakout connector.
12.
In the LHS of the luggage compartment, connect the trailer harness ground ring
terminal to the vehicle grounding point.
13. Connect the trailer patch harness 12-way connector to the ECU (04826).
14. Apply double sided tape to the ECU and adhere it to the outward face of the inner sheet
metal on the RHS of the luggage compartment.
For vehicles produced from May 2007–June 2010:
15. Locate the ‘Towing’ fuse location.
16. Insert the (supplied) 30-amp fuse into the ‘Towing’ fuse location.
For vehicles produced from July 2010 to 2013:
17. Locate the ‘Towing’ fuse location.
18. Insert the (supplied) 30-amp fuse into the ‘Towing’ fuse location.
19. Mount the trailer socket to the towbar mounting bracket using M4 fasteners (not
supplied).
20. Route the tail harness across the towbar towards the LHS of the vehicle and up through
the previously drilled out hole.
21. Ensure the tail harness grommet is seated correctly and secure in place using a cable
