Operating Your Sign
Operating Your Sign
After your sign is mounted and powered, you can connect to and manage it via Bluetooth with our easy to
use SafePace® Pro application. You can also manage your sign remotely using SafePace® Cloud, if you
purchased that option.
For more information on operating your sign with SafePace® Pro, refer to the
SafePace® Pro User Manual
.
For more information on operating your sign with SafePace® Cloud, refer to the
Web Director User Guide
.
T
IP
:
You can get the latest version of all manuals at:
http://www.trafficlogix.com/customerarea/customerdownloads.
Resetting the Sign
There is no ON/OFF switch supplied with the SafePace EV12FM sign. The sign immediately powers on once
the power source is connected. There is also no reset button on the controller card included with this sign.
As a result, we recommend that you use the following procedure to turn the sign OFF and ON, or reset the
sign.
To reset the sign:
1.
Open the sign enclosure.
On the inside of the front panel you will see the controller card and below it two green plugs. One of
these is wired to the controller card, the other is wired to the power source.
2.
Disconnect the lower of the two plugs, the one which is wired to the power source. This turns the sign
off.
3.
Wait a couple of seconds then reconnect the plug. The sign will immediately power on.
W
ARNING
:
It is vitally important, whenever you close the sign, that you close and lock
all
of the latches
properly to avoid water infiltration as this could damage the sign and void your warranty.
SafePace® Evolution 12FM Installation Manual
p. 31
