WHY DOES MY GRILL FIRE GO OUT ON “SMOKE” SETTING?
Excess ash in the Firepot may be the problem.
1) Open the Door and remove the Porcelain Grill, Grease Drain Pan and Heat Baffle
from inside the Grill.
2)
IMPORTANT: Remove all unburned Pellets and ash from inside and around
the Firepot.
A shop-vac is ideal tor this task
CAUTION! ASSURE THAT THE
GRILL IS COLD TO AVOID A FIRE FROM HOT ASH.
3) Replace the Heat Baffle, Grease Drain Pan and the Porcelain Grill and initiate start-
up procedure.
4) If this didn’t remedy the problem, contact Traeger Technical Support
(SECTION
SEVEN)
for additional troubleshooting help.
WITH THE TRAEGER DIGITAL CONTROL, WHAT DIAL SETTING IS
RECOMMENDED FOR STARTING THE GRILL?
The auto-start procedure is the same for all Grill Controls. With the Door open, turn
the Switch/Dial ON and Temperature Dial to SMOKE. In approximately 2 minutes
you will notice whitish-gray smoke coming out of the Grill as the Pellets ignite. After
assuring the Pellets have ignited, close the Door and set the Temperature Dial to
any cooking setting desired.
HOW DO I PROTECT MY PAINT FINISH?
1) Use a protective Cover on the Grill and touch-up paint to repair any scratches.
A
TRAEGER GRILL COVER to protect the Grill is highly recommended! Covers
and touch-up paint are available from your Traeger Dealer, or log on to our
Web Site –
www.traegergrills.com
.
2) Every 90 days, use a high quality car wax on the outside surfaces of the Grill. ONLY
APPLY WAX TO A COLD GRILL.
WHERE CAN I GET A NEW PART FOR MY GRILL?
Check with your Traeger Dealer. They may have the part in stock or can order the part
for you. Or you can contact the Traeger Parts Department
(SECTION SEVEN)
to place
an order. In either case, please provide your name, phone number, address, Model and
Serial Number of the Grill (located on a label inside the Hopper Lid), along with the part
identification number from the Component Diagram.
Содержание BBQLHS
Страница 14: ...BBQLHS COMPONENT DIAGRAM ...
Страница 16: ......