Traeger BBQ150.01, Руководство пользователя

Страница: 19 / 24

d) Disconnect Power Cord from electrical outlet and remove Pellets from the Pellet
Hopper. Check for foreign objects and wet/decomposed Pellets, both of which can
cause a jam in the Auger system. The Auger will need to be removed to clear a jam in
the Auger system. See “HOW DO I REMOVE THE AUGER IF IT JAMS?” section
below.
` HOW DO I REMOVE THE AUGER IF IT JAMS?
1) Remove any covers necessary to access the Auger Drive Motor.
2) Remove the screw connecting the Auger Drive Motor shaft to the Auger shaft and the
screw retaining the Auger Bushing into the Auger Tube.
3) With a small pipe wrench or locking pliers on the Auger shaft, turn the Auger counter
clockwise. It will turn hard until it breaks free, then the Auger will turn freely.
4) Remove the Auger and clean all Pellets, ash or foreign objects from the Auger, Auger Tube
and Firepot. A shop-vac is ideal tor this task.
5) Sand the outside surfaces of the auger with medium grit sandpaper. Check the inside of the
Auger Tube and sand it if needed. Vacuum the sanding grit out of the Auger Tube and
Firepot when finished.
6) Reinstall the Auger Bushing and the Auger into the Auger Tube, making sure that the Auger
rotates freely.
7) Re-attach the Auger shaft to the Auger Drive Motor shaft.
WHY DOES MY GRILL FIRE GO OUT ON “SMOKE” SETTING?
Excess ash in the Firepot may be the problem.
1) Open the Door and remove the Porcelain Grill, Grease Drain Pan and Heat Baffle from
inside the Grill.
2) IMPORTANT: Remove all unburned Pellets and ash from inside and around the
Firepot. A shop-vac is ideal tor this task CAUTION! ASSURE THAT THE GRILL IS COLD
TO AVOID A FIRE FROM HOT ASH.
3) Replace the Heat Baffle, Grease Drain Pan and the Porcelain Grill and initiate start-up
procedure.
4) If this didn’t remedy the problem, contact Traeger Technical Support (SECTION SEVEN)
for additional troubleshooting help.
WITH THE TRAEGER DIGITAL CONTROL, WHAT DIAL SETTING IS RECOMMENDED
FOR STARTING THE GRILL?
The auto-start procedure is the same for all Grill Controls. With the Door open, turn the
Switch/Dial ON and Temperature Dial to SMOKE. In approximately 2 minutes you will
notice whitish-gray smoke coming out of the Grill as the Pellets ignite. After assuring the
Pellets have ignited, close the Door and set the Temperature Dial to any cooking setting
desired.
HOW DO I PROTECT MY PAINT FINISH?
1) Use a protective Cover on the Grill and touch-up paint to repair any scratches. A
TRAEGER GRILL COVER to protect the Grill is highly recommended! Covers and
touch-up paint are available from your Traeger Dealer, or log on to our Web Site –
www.traegergrills.com .
2) Every 90 days, use a high quality car wax on the outside surfaces of the Grill. ONLY
APPLY WAX TO A COLD GRILL.
WHERE CAN I GET A NEW PART FOR MY GRILL?
Check with your Traeger Dealer. They may have the part in stock or can order the part for you.
Or you can contact the Traeger Parts Department
(SECTION SEVEN) to place an order. In
either case, please provide your name, phone number, address, Model and Serial Number of
the Grill (located on a label inside the Hopper Lid), along with the part identification.