Traeger BBQ055.04, Руководство пользователя

Страница: 6 / 16

SECTION THREE: SUBSEQUENT START-UP
With the Door open, turn the Switch ON (--) and the Temperature/Dial to SMOKE. In
approximately 2 minutes you will notice whitish-gray smoke coming out of the Grill as the
Pellets ignite. After assuring the Pellets have ignited, close the Door and set the
Temperature/Dial to any cooking setting desired. The Grill should be allowed to pre-heat
for approximately 10 minutes with the Door closed before placing food in the Grill.
WARNING! If at any time, the Grill fails to light or the fire in the Firepot goes out while cooking
or smoking, when sufficient pellets are still in the Pellet Hopper, it is important to follow these
steps. Failure to do so may cause a hazardous “over-firing” of your grill due to an excess of
unburned pellets in the Firepot.
1) DANGER! Turn the Switch OFF (o) and disconnect the Power Cord. If the Grill is still hot,
allow it to thoroughly cool. Open the Door and remove all food, the Porcelain Grills,
Grease Drain Pan and the Heat Baffle.
2) WARNING! Remove all unburned pellets and ash from inside and around the Firepot.
(See instructions for proper handling and disposal of ash in Section Five)
3) Before replacing the Heat Baffle, Grease Drain Pan and the Porcelain Grills, plug the
power Cord into an appropriate, grounded electrical outlet and restart the Grill. Pellets
should fall into the Firepot and the Hot Rod should begin to heat (it will start to turn red).
CAUTION! Do not touch it.
4) If this procedure is successful, you will soon see flames come out of the Firepot. Then turn
the Switch OFF (o) , and let the Grill cool down. Position the Heat Baffle, the Grease Drain
Pan and Porcelain Grill in their proper locations. With the Door open, turn the Switch ON (--
) and the Temperature/Dial to SMOKE. In approximately 2 minutes you will notice whitish-
gray smoke coming out of the Grill as the Pellets ignite. After assuring the Pellets have
ignited, close the Door and set the temperature/Dial to any cooking setting desired.
5) If this procedure is not successful, see Section Six: FREQUENTLY ASKED QUESTIONS
for troubleshooting tips or contact Traeger Technical Support (Section Seven) to help
diagnose the problem before proceeding to the MANUAL LIGHTING INSTRUCTIONS
below .
MANUAL LIGHTING INSTRUCTIONS:
If the Hot Rod only is not operating, the Grill can still be used to cook and smoke using the
MANUAL LIGHTING PROCEDURE below:
1) DANGER! Turn the Switch OFF (o) and disconnect the Power Cord. Allow the Grill to
thoroughly cool if it is still hot. From beneath the Pellet Hopper, disconnect the Hot Rod
(Purple / White wire pair as shown in the wiring diagram near the end of this manual). You
will need to remove the Hopper Bottom Panel to access the wiring. Once the Hot Rod is
disconnected, replace the Hopper Bottom Panel and plug the Power Cord back into an
appropriate, grounded electrical outlet.