Traeger BBQ020, Руководство пользователя

Страница: 9 / 17

recommended! Covers are available from your local Traeger Dealer, or log on to our
Web Site –
www.traegergrills.com .
4) Depending on use, periodically remove the Porcelain Grill, Grease Drain Pan Assembly
and clean the ash from in and around the Firepot. A shop-vac is handy for this chore. Make
sure the Grill is COLD before starting this procedure.
5) We recommend keeping a long-handled cleaning brush near the Grill. After removing your
food, give the Porcelain Grill a quick brushing. It takes only a minute and it will be ready the
next time you want to use the Grill.
Be careful not to burn yourself.
SECTION SIX: FREQUENTLY ASKED
QUESTIONS
WHY WON’T MY GRILL IGNITE?
1) Verify power at the electrical outlet.
a) If Power Cord is connected to a GFI (Ground Fault Interrupter), check and reset
if necessary.
b) Initiate startup.
Still no ignition – Proceed to step 2.
2) Disconnect Power Cord from electrical outlet.
a) Remove the Control and check the fuse on back. Replace the fuse if blown.
Reinstall the Control!
b) Unplug Hot Rod connector (Purple/White wire pair), plug Power Cord into an
appropriate, grounded electrical outlet and turn the Switch to ON and the Dial Knob to
the Smoke Setting. NOTE: At this point the Grill will not ignite.
c) Check the Draft Inducer Fan and the Auger Drive Motor for operation. If both
are operating -- the Hot Rod needs to be replaced. If one or both are not
operating, contact Traeger Technical Support
(SECTION SEVEN) for additional
troubleshooting help. Contact your Traeger Dealer or the Traeger Parts
Department
(SECTION SEVEN) to place an order.
3) If the problem is identified to be a failed Hot Rod, the Grill can still be used to cook and
smoke by following the MANUAL LIGHTING INSTRUCTIONS in SECTION THREE of this
OWNER’S MANUAL.
WHY ARE NO PELLETS BEING DELIVERED INTO THE FIREPOT?
1) Verify that there are Pellets in the Pellet Hopper. If this is the
INITIAL FIRING or the Grill
has run out of Pellets, allow sufficient time for the Pellets to travel from the Pellet Hopper to
the Firepot (can take up to 7 minutes).
2) Initiate startup. See INITIAL FIRING INSTRUCTIONS in SECTION TWO of this OWNER’S
MANUAL.
Still no Pellets in the Firepot – Proceed to step 3.
3) Disconnect Power Cord from electrical outlet.
a) Unplug the Auger Drive Motor ( Red/White wire pair connector) and the Draft
Induction Fan (Orange/White wire pair connector).