Traedgard Design Rantum, Инструкция по эксплуатации

Страница: 15 / 32

14
EN
•
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
•
The unit is for outdoor use only. It's not allowed to use in building site,
greenhouses, barn or stable where there's flammable dust.
•
The head of the unit is at high temperature during operation. Unplug the unit
and wait till it's cool before cleaning.
•
The unit should be plugged in a socket, which is easily visible and reachable.
WARNING:
This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable
of leaving the room on their own, unless constant supervision is provided.
Preparation
1. Prepare a cross head screw driver.
2. Read this instruction manual carefully before installation and use. Keep this
instruction manual and warranty card in a proper and safe place for future use
in case needed.
Installation:
1. Put the main body up-side-down (Fig. A). Slide Deco. Board (#6) onto Base
Bracket (#5). Put the plug (#8) and power supply cord through the holes on
the center of Base Cover (#4) and Base (#3). Then slide Base Cover (#4) , Base
(#3) and Washer (#2) onto Base Bracket (#5) respectively.
2. Fix Washer (#2), Base (#3), Base Cover (#4) and Base Bracket (#5) with Screw
M6*20 (#1). Clip the power supply cord with Cord Clip (#7) and fix it onto Base
(#3) with Screw (#9).
3. Stand the unit correctly (Fig. C). Fix L Bracket (#13) onto Alum. Fixtures (#10)
with Screw M8*6 (#12) & M4*6 (#11) respectively. Then slide L Bracket (#13)
into the holes of Control Box (#14).
4. Fix L Bracket (#11) onto Control Box (#11) with Screw M6*16 (#15).